07-24-2012 11:46 AM - edited 03-07-2019 07:57 AM
Hi
One of the 6500 was going in bootrom mode, so I have formated the flash disk using the other Cisco 6500 switch and copied IOS file to the boot disk. But the 6500 booting failed with the following error
rommon 1 > boot disk0:/s72033-adventerprisek9_wan-mz.122-33.SXI9.bin
Loading image, please wait ...
Initializing ATA monitor library...
*** Illegal Opcode Exception ***
PC = 0x801060e4, Cause = 0x28, Status Reg = 0x30409003
monitor: command "boot" aborted due to exception
Awaiting your kind revert
Regards
R.Krishnan.
07-24-2012 02:52 PM
PC = 0x801060e4, Cause = 0x28, Status Reg = 0x30409003
monitor: command "boot" aborted due to exception
This looks like the IOS is corrupt.
07-24-2012 03:02 PM
Check the bootdisk/bootflash for any crashfiles. Might also be a corrupted IOS. Best way to confirm is to take a flash from another working 6500 after testing SXI9 to be working over there and use the same disk in this device. Not the easiest of methods
-Karthic
07-24-2012 03:17 PM
Check the MD5 hash with YOUR file against the Cisco website.
Use the command "verify /md disk0:IOS.bin". At the end of the process is long line of alpha-numeric numbers. Compare that value against the Cisco website.
If they don't match you may need to download the IOS from the website once again.
07-24-2012 03:19 PM
leolaohoo wrote:
Check the MD5 hash with YOUR file against the Cisco website.
Use the command "verify /md disk0:IOS.bin". At the end of the process is long line of alpha-numeric numbers. Compare that value against the Cisco website.
If they don't match you may need to download the IOS from the website once again.
Good point Leo.
07-24-2012 03:27 PM
Thanks Karthic.
07-26-2012 03:16 PM
Would be very nice if the OP can give us an update to this as some people may find this thread useful.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide