01-10-2021 07:31 AM - edited 01-10-2021 07:36 AM
I currently have a 6506-E with a single SUP 720 as one of my distributions for access switches and last night I had an issue with a TM_DATA_PARITY_ERROR and sent this SUP into ROMMON mode. Our after market support stated this could be an environmental issue that caused this but this switch has been running for years in the same closet and I'm not aware of any environmental changes.
I'm monitoring the SUP to see if the occurs again but I was curious on how to swap the current SUP with a replacement if I have to go this route. If I have to swap I would most likely get the same mode SUP 720. Would I just need to remove the old SUP and put the new one in along with the old flash cards and be good to go?
Thank you
01-26-2021 12:51 PM
Output of dir bootflash:
Directory of bootflash:/
1 -rw- 277735 Oct 17 2006 10:28:26 -05:00 crashinfo_20061017-152826
2 -rw- 423186 Jan 9 2021 18:59:00 -06:00 crashinfo_RP_20210109-185900-CDT
01-26-2021 02:03 PM
@MFLauder wrote:
2 -rw- 423186 Jan 9 2021 18:59:00 -06:00 crashinfo_RP_20210109-185900-CDT
Please attach the file so we can have a look.
10-24-2021 07:07 AM - edited 11-04-2021 10:28 PM
Can the Cat 8K do SRTP to SRTP Transcoding? The ISR4K could not do SRTP to SRTP Transcoding, so one of our customers went with a competitor who may want to do SRTP to SRTP transcoding for 3D rendering Service to be used as an SBC in preference to CUBE.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide