10-22-2013 03:26 AM - edited 03-07-2019 04:10 PM
Hello All,
Bit confused with output of show flash and show boot where is actual image used why it says slot0 in Boot and show version has image
'bootflash:BTSYNC_cat6000-supk8.7-6-10.bin
----------------
(enable) sh flash
-#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name
1 .. ffffffff bdfea4c9 a32d14 31 10431636 Jun 06 2005 13:48:47 BTSYNC_cat6000-supk8.7-6-10.bin
5559020 bytes available (10431764 bytes used)
EBRSW012> (enable)
----------------
(enable) sh boot
BOOT variable = bootflash:BTSYNC_cat6000-supk8.7-6-10.bin,1;slot0:ebrsw010\cat6000-supk8.7-6-10.bin,1;
10-22-2013 03:59 AM
Hi Amit,
Try the following:
clear boot system flash slot0:ebrsw010\cat6000-supk8.7-6-10.bin
Regards
Richard
10-22-2013 04:12 AM
Thansk Richard for reply please advise if this is service impacting command or only does refresh , also is there reboot required after this command ?
Regards
Amit
10-22-2013 04:17 AM
Hi Amit,
This command is not service impacting.
I just clear out the second (wrong) boot variable. After the command show boot should just show the correct bootflash: entry. A reboot isn't needed for that, but maybe you have to save the config to see the change under show boot.
Regards
Richard
10-22-2013 04:33 AM
Thanks Richard , It seems to be working One query so "bootflash" is just name of a name remane of name of image or or is it a directory
(enable) sh flash
-#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name
1 .. ffffffff bdfea4c9 a32d14 9 10431636 Jun 14 2005 12:42:44 bootflash
5559020 bytes available (10431764 bytes used)
> (enable) sh boot
BOOT variable = bootflash:bootflash,1;
CONFIG_FILE variable = bootflash:switch.cfg
Configuration register is 0x2
ignore-config: disabled
auto-config: non-recurring, overwrite, sync disabled
ROMMON console baud: 9600
boot: image specified by the boot system commands
10-22-2013 04:36 AM
could you post the output of:
dir bootflash:
I think this should also work under catos.
Regards
Richard
10-22-2013 04:44 AM
Please find output below
> (enable) dir bootflash:
-#- -length- -----date/time------ name
1 10431636 Jun 14 2005 12:42:44 bootflash
5559020 bytes available (10431764 bytes used)
10-22-2013 04:46 AM
Is this a different device?
what is the output of
dir bootflash:bootflash/
10-22-2013 05:18 AM
hello Richard ,
Yes its different switch , please find output below
(enable) dir bootflash:bootflash/
No such file
If any one can reply please
10-24-2013 01:06 AM
Hello ,
If anyone can help please
Regards
amit
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: