11-22-2010 07:03 AM - edited 03-06-2019 02:09 PM
Dear All ,
We are usng a Cisco 6509 running CatOS 7.1(2) to apply QOS Policing for Rate Limiting. The QOS Configuration we usually use are as follows :
Example : Subnet = 10.150.10.0 / 24
" set qos policer aggregate Example_Dwn rate 256 burst 64 drop
set qos ploicer aggregate Example_up rate 64 burst 32 drop
set qos acl ip Dwnload dscp 0 aggregate Example_Dwn ip any 10.150.10.0 0.0.0.255
set qos acl ip upload dscp 0 aggregate Example_up ip 10.150.10.0.0.0.255 any "
The above configuration illustrate that Subnet 10.150.10.0 / 24 will be have a Policy applied with 256 Kbps for Download & 64 Kbps for Upload.
Lately , When we tried to Submit a New Subner ( 10.150.20.0 / 24 ) to apply new Policy for this Subnet , We were prompted with the below Error :
" Aggregate plicer table is full. cannot add additional entries.
Failed to set qos policer for aggregate Example2_Dwn "
Any CatOS Expert can give us a Hand with this issue ?
11-24-2010 01:12 PM
what are the SUP and PFC on the chassis? Any DFC in the chassis? Different PFC and DFC have different number of aggregate policer. Normally, it is 1023. The number of aggregate policers is the same for native and hybrid.
It looks like that you run out of aggregate policer. Show tech of the switch is help.
11-25-2010 01:46 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide