cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

777
Views
0
Helpful
17
Replies
Highlighted
Beginner

Re: 6509E Model

Thanks I did check the power supply connection to the Ups and one Had come Loose

after reseting the connector Led turned to Green.

Thank you for the support

Rising star

Re: 6509E Model

Yes everything looks OK thus far. Try the "show diagnostic content module 5" command. This will show the advanced diagnostics on the line card, and show any failed tests.

Cisco Employee

6509E Model

"show module" output shows that both the supervisors are up and have passed all the diagnostic tests - so both the supervisors are working fine and in good state. If there is any problem with the module then you would see it in the "show module", "show logging buffer 1023" & "show log".

We can also clearly see that the standby supervisor is in redundant hot state, and has synced up with the active. So i dont see any issues with any of the modules.

Regards,

Ranganath

(TAC)

CreatePlease to create content
Content for Community-Ad