cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

116
Views
0
Helpful
2
Replies
Beginner

6807 2T VSS quad migration instructions

I'm struggling to find documentation that outlines the steps needed to migrate from dual sup 2Ts to quads in a 6807 VSS (no code upgrade; just hardware addition).   I expect code 15.5 to be on the device at the time.   Any suggestions?    thank you 

2 REPLIES 2
Highlighted
VIP Advisor

Re: 6807 2T VSS quad migration instructions

you can install the module as mentioned below guide : (make sure all the IOS same and same model of Supervisor -in your case Sup2T)

 

https://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/71585-cat6k-red-supeng-swimg-upg.html

 

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/hardware/Module_Installation/Mod_Install_Note/78_15767.html#wp40738

BB
*** Rate All Helpful Responses ***
Beginner

Re: 6807 2T VSS quad migration instructions

BB  I have the impression your links are for a standalone chassis.  I think the VSS is a bit different.  I'm assuming the new hw will drop into rommon (see table 4)  https://manualzz.com/doc/17955617/virtual-switching-system-quad-supervisor-stateful-switchover

 

 

 

CreatePlease to create content
Content for Community-Ad