9200L HSRP configuration

[icbsheff2001]

I am using a 9200L switch as a layer 3 device. I have configured a number of SVI's which are up and working. IP routing is working fine OSPF routes are being advertised OK. My problem is i am unable to configure the SVI's to use HSRP. 

Under the SVI I am unable to use the standby command it is not within the list. Has anyone else come across this issue and if so how was it resolved?.

[paul driver]

Hello

---

@icbsheff2001 wrote:

My problem is i am unable to configure the SVI's to use HSRP. 

Under the SVI I am unable to use the standby command it is not within the list. Has anyone else come across this issue and if so how was it resolved?.

---

Conf t

feature hsrp
interface Vlanx
hsrp xx
preempt
priority xx
ipx.x.x.x

[icbsheff2001]

Thank you for your response. Unfortunately the switch does not recognise the feature command.

TestCISSW01(config-if)#feature hsrp
% Invalid input detected at '^' marker.

[andrew.butterworth]

I am guessing you only have Network Essentials license?  You need Network Advantage license for HSRP according to this link.

https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-9200-series-switches/nb-06-cat9200-ser-data-sheet-cte-en.html

Try enabling NA (license boot level network-advantage), and see if it appears.  I have just tried on a 9200L I have access to and see the same behaviour - i.e. no 'standby' command under the SVI, however OSPF is available for routed access.