07-13-2022 04:01 AM - edited 09-04-2022 11:11 PM
Hi Team,
Can some once share the IOS upgrade procedure of Cisco 9300 stack switch.
07-13-2022 04:12 AM - edited 07-13-2022 04:33 AM
- Strong advise to read the Release Notes for targeted version , which will also point you to installation instructions and or guide(s). You also may find this document informational : https://blog.noblinkyblinky.com/2019/07/27/upgrading-ios-xe-on-catalyst-9000-series-switch-stack/
M.
07-13-2022 07:28 AM
how we can do one by Switch reboot after pushing the IOS
When doing the code update you cannot reboot one Switch at a time, instead you need to reboot all Switches on that Switch Stack at the same time.
This guide below has some general steps on the code update and differences between Bundle Mode and Install Mode.
Upgrade Guide for Cisco Catalyst 9000 Switches | Polaris IOS Install Modes Overview
If your device is on Install Mode then as @marce1000 mentioned you can check the release notes of the code you are updating to and find the step-by-step guide there:
Release Notes for Cisco Catalyst 9300 Series Switches, Cisco IOS XE Amsterdam 17.3.x | Upgrading in Install Mode
Release Notes for Cisco Catalyst 9300 Series Switches, Cisco IOS XE Bengaluru 17.6.x | Upgrading in Install Mode
07-13-2022 03:46 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: