01-25-2015 02:51 AM - edited 03-07-2019 10:22 PM
Hello,
I should put a second router HSRP for redundancy.
there are two interfaces on this router F0 / 0 operator and f0 / 1 Lan, I think implement HSRP only on the F0 / 0, knowing that the F0 / 1 there there's many sub interfaces config see below . Is this may be a problem
I must also change the C8114 router replacement router which you propose
Thanks
MA
Solved! Go to Solution.
01-25-2015 06:54 AM
Its up to you. You can use another c1841. Depends on how many clients you have. If you are happy with the performance of the 1841 then you can use a second 1841.
01-25-2015 03:42 AM
Hi. You can implement the HSRP both ways for redundancy on each vlan sub-interface tgat you want failover on. I would recommend you share the load between routers by making some vlans active on the 1 router, and some on the other. What is connected to the c1841?
01-25-2015 04:20 AM
Hi. Thank you for your reply, for the load share between routers, that is to say, for exemple, I activate HSRP on router 1 for the vlan 100 and activate HSRP for VLAN 111 in the router 2. !
I must change t the router C1841 with a new génereation which you recommend C3750 ?
Thanks
01-25-2015 06:54 AM
Its up to you. You can use another c1841. Depends on how many clients you have. If you are happy with the performance of the 1841 then you can use a second 1841.
01-25-2015 09:29 AM
Hi. I'm sorry, but I just realized that you asked a question with the post about Vlan 100 active on router 1 and vlan 111 active on router 2....... yes. That is what I meant. I hope you get it working.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide