cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
835
Views
0
Helpful
6
Replies

Access point not working

sathyasav
Beginner
Beginner

I have a 1130 cisco access point,we are using this for wireless cisco IP phone connectivity to the network.Earlier access point was woring fine and we were able to make calls through IP phone.But we have relocated to new place.Now the access point is not working and we are not able to make the calls on the wireless IP phone as the access point is not working.But the access is in the netwrok and we are able to ping the IP address of the Access point.

We are contonuously getting the below loggs on Access point and the access point is getting power from the ethernet port of the switch not through the external powerr adaptor.

error message:

: %CDP_PD-2-POWER_LOW: All radios disabled - NEGOTIATED WS-C

4507R (0012.7fb6.6e6c).

Please tell me is this error message the source of the issue or how to make this work.

Thanks,

Sathya.

6 Replies 6

glen.grant
Advisor
Advisor

   Either the power injector or the switchport is not supplying enough power for the AP for some reason and the AP is shutting the radios off .  Troubleshoot the power issue.

ebarticel
Enthusiast
Enthusiast

Also check the power settings on the switch port that is connected to AP and that cdp is enabled on that switch port.

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

1.  Some 4000/4500 line cards will only operate up to 7.5w of PoE.  Can you post the output to the command "sh module"?

2.  You sure you have enough PoE power?