Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
437
Views
0
Helpful
1
Replies

ACE Load Balancer

shyamatopsource
Level 1
Level 1

‎02-15-2007 06:23 AM - edited ‎03-05-2019 02:22 PM

Hi,

I am a newbie in this forum.. Can you please tell me whether I can specify a range of ports from the Public IP to the Internal servers. Normally the F5 does not allow you to add range of ports for a mapping..

Thanks

Shyam

Labels:
0 Helpful
1 Reply 1

spremkumar
Level 9
Level 9

‎02-15-2007 08:25 PM

Hi Shyam

If you are asking about doing the static port translation in your Cisco box ofcourse its possible to do the same.

you can refer the below link to get started..

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_white_paper09186a0080091cb9.shtml

regds

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card