hi all ,
Can any one plz tell the command to see the allowed/opened ports in 7206 router?
From the privileged (enable) EXEC propmt, type:
sh ip int br
...should give you what you need, eg:
#sh ip int br
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/1 unassigned YES NVRAM up up
GigabitEthernet0/2 unassigned YES NVRAM up up
GigabitEthernet0/3 unassigned YES NVRAM up up
GigabitEthernet1/0 unassigned YES NVRAM administratively down down
FastEthernet2/0 unassigned YES NVRAM up up
FastEthernet2/1 unassigned YES NVRAM administratively down down
Tunnel0 unassigned YES unset up up
Tunnel1 unassigned YES unset up up
Tunnel2 unassigned YES unset up up
Tunnel3 unassigned YES unset up up
There can be various, if you are concerned best approach is to run a portscan at it.
Thanks Paolo for the reply . From CLI can we get it ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: