allowed ports in cisco 7206vxr router

[vijay kumar]

     hi all ,      

Can any one plz tell the command to see the allowed/opened ports in 7206 router?

[Seb Rupik]

Hi Vijay,

From the privileged (enable) EXEC propmt, type:

sh ip int br

...should give you what you need, eg:

#sh ip int br

Interface                  IP-Address      OK? Method Status                Protocol

GigabitEthernet0/1         unassigned      YES NVRAM  up                    up     

GigabitEthernet0/2         unassigned      YES NVRAM  up                    up     

GigabitEthernet0/3         unassigned      YES NVRAM  up                    up     

GigabitEthernet1/0         unassigned      YES NVRAM  administratively down down   

FastEthernet2/0            unassigned    YES NVRAM  up                    up     

FastEthernet2/1            unassigned      YES NVRAM  administratively down down   

Tunnel0                    unassigned      YES unset  up                    up     

Tunnel1                    unassigned      YES unset  up                    up     

Tunnel2                    unassigned      YES unset  up                    up     

Tunnel3                    unassigned      YES unset  up                    up

cheers,

Seb.

[paolo bevilacqua]

There can be various, if you are concerned best approach is to run a portscan at it.

[vijay kumar]

Thanks Paolo for the reply . From CLI can we get it ?

Thanks!,

Regards,

Vijay