cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
533
Views
0
Helpful
4
Replies

Any equivalent command to "show storm-control" on Cisco 6800?

smeroz
Level 1
Level 1

With c3750 it was very easy to display table of multicast levels by executing: "show storm-control multicast". I can't find similar a way to do this with c6800. I'm trying to identify which device caused the storm-control mechanism to send a trap. 

Any other useful commands related to this topic will be also appreciated (maybe related to mroute, mfib etc).

4 Replies 4

show interfaces counters storm-control

please check this command 

Hi, thanks for your response. This will display a table with the configured levels and the amount of violations but not the current level (The 3750 shows also the current level).

marce1000
VIP
VIP

 

 - Perhaps :  show storm-control broadcast ,

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Hi, thanks for your response. This command is not available with C6800.

Review Cisco Networking for a $25 gift card