cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1618
Views
0
Helpful
2
Replies

ASDM Catalyst 3560

isaacmora
Beginner
Beginner

I have a Catalyst 3560'm trying to use ASDM, i do not know how to set it

1 Accepted Solution

Accepted Solutions

Good morning  isaac mora

Thanks for using our forum

In order  to enable ASDM, follow this steps in the router configuration.

Assign an IP address to the router:      ip address x.x.x.x y.y.y.y

Create a username:    ( username privilege 15 password 0 )

Enable Http server:    ( Ip http server)

Enable Http secure-server :      (Ip http secure-server )

Enable local authentication :    ip http authentication local

Set a enable password :    ( Enable secret cisco)

Enable local Authentication :       

Line vty 0 15

   Login local

   privilege level 15

   transport input telnet
   transport input telnet ssh 

Then  to access the SDM, you have to access from the bowser and enter the router's IP

I hope you find this answer useful, if it was satisfactory  for you, please mark the question as Answered.

Greetings,

Johnnatan Rodriguez Miranda.

View solution in original post

2 Replies 2

Karsten Iwen
VIP Mentor VIP Mentor
VIP Mentor

ASDM is the GUI for the ASA firewall. For switches you can use the embedded Device-Manager (if installed).

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni

Good morning  isaac mora

Thanks for using our forum

In order  to enable ASDM, follow this steps in the router configuration.

Assign an IP address to the router:      ip address x.x.x.x y.y.y.y

Create a username:    ( username privilege 15 password 0 )

Enable Http server:    ( Ip http server)

Enable Http secure-server :      (Ip http secure-server )

Enable local authentication :    ip http authentication local

Set a enable password :    ( Enable secret cisco)

Enable local Authentication :       

Line vty 0 15

   Login local

   privilege level 15

   transport input telnet
   transport input telnet ssh 

Then  to access the SDM, you have to access from the bowser and enter the router's IP

I hope you find this answer useful, if it was satisfactory  for you, please mark the question as Answered.

Greetings,

Johnnatan Rodriguez Miranda.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers