cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
426
Views
0
Helpful
2
Replies

Assistance to Setup Vlan with Access Points & Controller

ghansham
Level 1
Level 1

HI Guys,

I am having issues setting up a layer 3 Cisco Sg 300 series switch for my APs and Controller.

My setup:

Vlan 30 - 192.168.30.0/24 - Vlan Interface -192.168.30.1

Vlan 60 - 192.168.60.0/24 - Vlan Interface -192.168.60.1 - DHCP Server

Vlan 70 - 192.168.70.0/24 - Vlan Interface -192.168.70.1 - DHCP Server

 

Controller 192.168.30.2

AP 1 - 192.168.30.3

AP 2 - 192.168.30.3

AP 3 - 192.168.30.3

SSID 1 - Vlan 60

SSID 2 - Vlan 70

 

I am getting dhcp from either vlans, but no internet neither can I ping the controller.

 

Any suggessions would be helpful of a better setup.

2 Replies 2

Hello

Can you post a topology of your network setup please.

regards internet access what device is performing the network translation for you vlans?


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Thanks for your response.

The nat is being done on the router.

Also when I use an access port with either vlan 60 or vlan 70, everything works. (internet, dhcp, etc)

Capture.PNG

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: