cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
871
Views
0
Helpful
3
Replies

Asymmetric bandwidth limit on Cat2960 or 3560

tranceparent
Level 1
Level 1

Hi everyone,

I have the requirement to assign an asymmetric bandwith limit to each port on a switch (example: 4Mbps downlink, 1Mbps uplink). I've been searching and found the option to apply policers or srr-queue mechanism to achive this, however this only applies for one direction only as far as I know.

Any ideas? Catalyst 2960 familiy is preferred, however if this is not possible, will possibly jump to the 3560X family.

Thanks in advance!

Regards

JS

3 Replies 3

Joseph W. Doherty
Hall of Fame
Hall of Fame

Disclaimer

The   Author of this posting offers the information contained within this   posting without consideration and with the reader's understanding that   there's no implied or expressed suitability or fitness for any purpose.   Information provided is for informational purposes only and should not   be construed as rendering professional advice of any kind. Usage of  this  posting's information is solely at reader's own risk.

Liability Disclaimer

In   no event shall Author be liable for any damages whatsoever (including,   without limitation, damages for loss of use, data or profit) arising  out  of the use or inability to use the posting's information even if  Author  has been advised of the possibility of such damage.

Posting

Not sure about the 2960, but believe you can police ingress on 3560/3750s.  Also believe both 2960s and 3560/3750 share similar egress features which include egress queue shaping and port bandwidth usage shaping.

Hi Joseph, how do you manage to shape teh egress traffic on a 2960?

I made some test and now I'm able to police the ingress traffic, but not the egress.

Thanks!

JS

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Hi Joseph, how do you manage to shape teh egress traffic on a 2960?

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/15.0_1_se/configuration/guide/swqos.html#wp1163879

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/15.0_1_se/configuration/guide/swqos.html#wp1253412

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco