cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3432
Views
0
Helpful
2
Replies
Highlighted
Beginner

Auto QOS for Catalyst 2960s with Avaya Phones

Have a client looking to implement VOIP using the following Avaya phones:

Avaya 1603-I

Avaya 1608-I

Avaya 9630G

Avaya 1616-I

They will be replacing all current switches with Catalyst 2960S 24 and 48 port switches, all PoE.  They also have Cisco 2811 routers that will route the traffic between each location.

I am not familiar with the setup of QoS and in researching I came across the Auto QOS command and wondered if this was something I could use with these switches and these phones. 

Was wondering if anyone could provide sample configuration of how the ports connecting to these phones should be configured if auto qos is a possibility.

Thanks!                 

2 REPLIES 2
Highlighted

Hello,

look at the following document that I have attached.

I have configured "auto qos" in one of our clients since a few years and works fine!!

They are content with the performance (more or less 200 phones).

Regards.

This is an example of the configuration for an interface phone.

pruebas-QoS# conf t

pruebas-QoS(config)# interface

pruebas-QoS(config-if)# description

pruebas-QoS(config-if)# switchport mode trunk

pruebas-QoS(config-if)# storm-control broadcast level pps 5124 1000

pruebas-QoS(config-if)# storm-control multicast level pps 5124 1000

pruebas-QoS(config-if)# storm-control action shutdown

pruebas-QoS(config-if)# spanning-tree portfast trunk

pruebas-QoS(config-if)# switchport voice vlan

pruebas-QoS(config-if)# auto qos voip trust 

pruebas-QoS(config-if)# switchport priority extend cos 0

Regards

Highlighted

are you sure this is working with an Avaya phone ?

Also, do you have any example for the LLDP Configuration for access port ?

Content for Community-Ad