possible to manually set the speed and duplex on a switch and for FLP to use those settings to negotiate with PCs that are set to Autonegotiate? I realize that once you manually set one end and leave the other end at autonego then the connection defaults to half duplex. But I am hoping that there is a feature or trick to only set one side and for the connection not to go to Half Duplex. Looking forward to responses..thx
No there is no way to do that . You have to match the sides for the links to work correctly. Both sides have to be auto or you have to hardcode both the switch and the nic card to the specific speed/duplex .
1. Log into CLI of DNAC:
ssh maglev@< DNAC appliance IP> -p 2222
2. Run this curl command to get token to get member id:
curl -X POST -u admin:<admin user password> -H -V https://<CLUSTER-IP>/api/system/v1/identitymgmt/token
Enterprise Switching Business Unit is glad to announce Beta release 16.12.2 for all Catalyst 9200/9300/9400/9500/9600 and Catalyst 3650/3850 Platforms. This release is made available to allow users to test, evaluate and share fee...
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The document assumes that the reader has a general overview of Cisco's SD-Access for Distributed C...
Do you currently have hands-on networking experience? If you do, we'd love to hear from you!
Your feedback will be reviewed and analyzed by our team to directly influence a networking management and monitoring product.
Take the 20-min or les...