Cisco Community
English
Register
COMMUNITY HELPING COMMUNITY - With your Community actions and contributions, we will donate up to $10,000 to UNICEF by end of January- PARTICIPATE
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
234
Views
0
Helpful
0
Replies
Highlighted
danielh23
Beginner
Beginner
‎10-18-2012 03:48 AM
‎10-18-2012 03:48 AM

Avaliable Bandwidth after apply policy map

I have a policy map apply in int g0/1.   When I do " sh int G0/1,  there is a "Avaiable Bandwidth 25000 kilobits/sec".   (pls see attached)

I wld like to know how I can calaculate 25000 kilobits/sec base on  this policy map.      

Labels:
Preview file
2 KB
0 Helpful
Reply
0 REPLIES 0
Latest Contents
EIGRP Preferred routes
Created by Lass11 on 11-28-2020 12:23 PM
0
0
0
0
Hi Guys, I have two questions about EIGRP behavior when we have Multiple EIGRP routes: 1- I tried to show on some router the acquired EIGRP paths for a route X.X.X.X by typing the command : "show ip eigrp topology X.X.X.X". On the output there w... view more
Use Serviceability Features to Troubleshoot your Cat9K as a ...
Created by ciscomoderator on 11-27-2020 10:37 PM
0
0
0
0
[ The Discussion forum will be published on December 1st ] Take the opportunity to reach out to our expert and discuss best practices regarding on how to troubleshoot a live network and identify the root cause easily. Learn more about Serviceability and h... view more
Remote Workforce Routing Solution - Cisco SD-WAN
Created by Randeep Singh on 11-25-2020 11:25 PM
2
10
2
10
Goal Network Admin To provide a solution to quickly setup a router at a remote location that supports WiFi and provides instant internet access using LTE as a transport while deploying with Cisco SD-WAN. Remote Worker Plug the router to a power sou... view more
EEM making a script more dynamic and automated
Created by fsebera on 11-25-2020 12:18 PM
0
0
0
0
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment.  This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ... view more
Nexus 9k tcpdump vs ethanalyzer
Created by ICANG on 11-25-2020 03:23 AM
1
0
1
0
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical  interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full... view more
Content for Community-Ad