I am curious about configuring bandwidth restrictions for specific VLANs through a switch. For example, restricting a guest Wi-Fi VLAN to 10 Mbps. While this can typically be done via a wireless controller, the customer requires this to be configured on the switch.
Option 1: If using access switches with a GUI, should I configure the bandwidth restriction for selected VLANs under the bandwidth section for each port that belongs to the VLAN, or should I use the VLAN ingress limit to specify the restriction for the VLAN itself, since the bandwidth section may be time consuming due to configuration for each port ?
Option 2: If configured on the core switch, what would be an example CLI command to implement this in a simplified manner?