The following is the Gateway Router external interface counters::::
stEthernet0/1 is up, line protocol is up
Hardware is Gt96k FE, address is 0013.c3c2.6c8b (bia 0013.c3c2.6c8b)
Description: INTERFACE TO CHN_TVM LINK
Internet address is 10.0.0.2/30
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 5/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:07, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/1024/0 (size/max total/threshold/drops)
Conversations 0/2/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 75000 kilobits/sec
-------------------------------------------
30 second input rate 1984000 bits/sec, 308 packets/sec
30 second output rate 757000 bits/sec,
-------------------------------------- 271 packets/sec
7297947 packets input, 2758474231 bytes
Received 1108 broadcasts, 0 runts, 0 giants, 0 throttles
1 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
Please, do look at the input rate and output rate.
My company is having 2Mbps link intranet link , I haven't set any bandwidth on this interface:
My doubt is the total bandwith utlization on the link would be the sum of
out put rate and input rate... OR only output rate,and only input rate... I just completed my CCNA .. I am total confused with this.. I would be grateful ,, If any one can give a reliable answer for that....