cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
392
Views
0
Helpful
3
Replies

Bandwidth Utilization of a class belonging to a policy map ..

rinish-mr
Level 1
Level 1

Team,

Is there any way to find out bandwidth utilization of a class belonging to a policy map ?

we had an issue recently that packet drops happens to 2-5 hosts only  in a class , same time another hosts were reachable . But these 5 hosts were reachable from another locations same time.

Regards,

Rinish

3 Replies 3

Joseph W. Doherty
Hall of Fame
Hall of Fame

Have you tried show policy-map interface?

Hi Joseph , 

Yes , i tried but it gives last 5 minutes utilization of physical interface where policies are applied .But my question is that is there any way to find out the bandwidth utilization of class ?

It might be version dependent, but later IOS show bps per class with that command.

e.g.:

GigabitEthernet1/0/9

 Service-policy input: QOS-POLICY-BORDER-IN

   Class-map: QOS-CLASS-EF (match-any)
     0 packets, 0 bytes
     5 minute offered rate 0 bps, drop rate 0 bps
     Match: ip dscp ef (46)
       0 packets, 0 bytes
       5 minute rate 0 bps

Also, 5 minute rate is tied to interface load interval.  I.e. if you change that, I believe policy stats will change too.

Review Cisco Networking for a $25 gift card