Switching

Hello,I'm having trouble making a trunk between these two switches;We have a cisco router with dmvpn and bgp that sends the DHCP scope to the network through the Huawei S5735 switch which is the core and from this switch a fiber goes out to the CBS25...

Have a bit of an odd situation with an SG300-28P.The switch performs just fine when connected to various peripherals (local PCs, media players, etc) however is thrown into a reboot cycle as soon as it's connected to the larger building network by way...

Hello! I have read about Meraki and Intersight. I have not dug deeper yet but these two platforms confuse me, both are for cloud management (deployment, monitoring, and support) of Cisco devices and network infrastructure. Could someone help to disti...

we use supervisor module in 4500,6500 switch and 9400 & 9500 switch so what is its role?why do we have primary and secondary supervisor Module ?is it CPU?command to check its status or performance 

Hi community, Good afternoon.Can anyone  please clarify whether the below condition/requirement is possible or not .Condition/Requirement : 1. Will SVI in Meraki support two DHCP subnets (Created in same DHCP server).2.when the DHCP pool of one subne...

Team,We have meraki switches, when we connect to POE it shows the dark orange light not green... Users are getting 100MBPS from POE and 1GBPS without POE. I am confused because of the led color 

I have never used that system before and before buying the device i need to make sure that if it is going to work correctly. So i have a couple of questionscan i register a used cisco device? if then yeshow can i configure and register to my cisco ac...

Hello Everyone!I'm very new to networking, although I've been addicted to learning more ever since I started working in the field. I've been securing my network to the best of my ability between a combination of youtube, CCNA books, reddit, Meraki su...

Difference between install Mode and bundled mode,please explain.in stacking --Bundled mode requires same IOS at all switch but in installed mode,Active switch push its IOS to member ones right?

I'm looking to set up a cisco Meraki MX85 security appliance to a stacked Cisco Catalyst 9300 (x2)MX85 > Stacked 9300 Catalyst Switch > PCMX85 WAN 1 > InternetMX85 Port 11 > 9300 g1/0/48MX85 Port 12 > 9300 g2/048 My questions are:1. What config needs...

How many vlans can be configured on a single port of a switch?