Hello,I have been trying to solve this project that was provided in my course.I am rather confused as to how to correctly construct my diagrams. I have googled how to configure ripv2, dhcp, vlan with vlsm and static routing. but I can't seem to draw ...
Forum Posts
Netgear has always been known for providing the best and easiest router login methods so that each and every user can get their routing and other networking devices accessed and set up. Just log into the router through routerloginnet and provide the ...
hello, if i have 2 layer 3 switches and a set of layer 2 access switches in between so it forms a loop (the layer 3 on the edges of the loop and the layer 2 access switch in between as a physical connectivity), is that will affect the HSRP response c...
hello, can i upload catalyst images to an industrial switch. if yes, how can it can be done. best regards,
hello, what kind of switches can we use instead of industrial 5000 switches with same or better performance specially for the operation environment category and have at least 8 10GB ports. the limitation of industrial 5000 switch is that include only...
Hi I have a problem to configure C-890-k9 switch – I mean to make acces user connected to Fa 1 port to the internet.I was trying to connect on Cisco Packet tracer and connection pass. ButWhen I’m trying to configure in real switch “C-890-k9” Fa8 ...
Hi, I have a situation where I need to enable SNAT for all outgoing traffic on Gi0/0/0.Wht is the config will looks like?Can I said tht traffic is only possible one way which is from LAN to DMZ?
How many subnets, Collision domain and broadcast domain in the following network (see attached)?
