Switching

Hello Experts,I am stuck in one issue , i am trying to apply PBR on SVI configured in VRF.Its throwing me error "Can not apply route-map to this interface if VRF is configured".Basically our next hop is in Same VRF , i want to match some host in ACL ...

I met a stack switch trouble, my model is C9200L-24T-4G, it is stack two, IOS version are 17.6.4, ROMMON are 17.9.1r. And I have HA failover test, the steps...1)sw1 is active, sw2 is standby, any fine currently.2)unplug 2 power cables on sw1(active),...

Hi All, Trying to wrap my head around this high priority issue that accidentally happened. I thought it was pretty safe practice to add a new vlan to existing trunk port by using the 'switchport trunk allowed vlan add <vlan>' command, however this br...

Will C9200L-48P-4X-E Model supports both1G & 10G transceiver modules, as per data sheet it shows 48 PoE+ , 4x10G switch. Just want to check if same switch model will support 1G transceiver module. 

This is a unique issue as TAC has been having a hard time figuring it out.  One minute it starts working, another it doesnt.  So to break it down, we are using: Not WorkingCatalyst 9410 -- Latest version 16.9.4 with two patches. WorkingCatalyst 4506 ...