Switching

Hey guys,  I am working under a new drawing , I am integrating a new switch ws-c2960L-8PS . Is there a way you could provide me the Visio Stencil for this ? Thanks in advance. RJG

Hi Everybody,We have a small lab in our company with 1 Cisco ASA 5515x Firewall, 1 Cisco 1941 Router , 2 Cisco C-2960-X24TS-LL Switches with simple configurations, this network is made to Support Vmware ESXi servers running in  our LAB for internal U...

Our overall network is massive, managed by the NOC. Our small team (independant from NOC) installs edge switches to tie equipment back to our server installation. We need to remotely access the switches to bounce POE ports, etc. and have a single VLA...

Hi, im trying to upgrade my cisco 2960x switch(c2960x-universalk9-mz.152-4.E8.bin). I have created a tftp server with tftpd64. Im using putty and my error message is:N-VIN-CIS-1169-#copy tftp flashAddress or name of remote host [158.149.64.62]?Source...

Hi, guys,ISP provides a internet line to my company, for the last mile WAN link ( their customer end), they provide two layer 2 lines connecting to our two separated C2960 switches ( as below ):ISP -----L2 Switch Line 1   -------- C2960-1 (vlan 10)  ...

Hi all, I have configured lacp between ASA 5516x and Cat6880 vss chassis. Portchannel and lacp status seems ok on both switch side and on ASA side. However, unless i do not shut one of the ports of lacp team on ASA, the traffic does not pass behind t...

Hey guys,I have a dilemma on my hands these days. We have here a couple of Cisco 2960 switches (one is -S, 3 are -X and one SG350-48P), that are currently connected through copper. The S is the master (connected to the firewall/router, APs, VLAN defi...

I was making a change to the master in the stack and went to reboot the system, but only rebooted the 1 Supervisor , 4500E . now its in standby mode. is there a way to reboot both supervisors through a command on the standby switch. I am remote, and ...

I use this method to backup all my switch configs: show running-config | redirect tftp://10.10.10.200/coreswitch.cfg However, I am having an issue getting this to work on our core switch. I do not get any errors. It outputs a 0 byte file. Here is the...

5 years ago prior to me being here, the company deployed 2960s switches to a remote plant. They left everything on VLAN 1. Vlan 1 is acting as the management and the data VLAN. Now, they want to introduce another VLAN.  On the router, it is subinterf...

Hi all,Hopefully a quick question. I’ve got a "flat" network I would like to split into several VLANs, I access the Internet via a Smoothwall box. I’ve got cisco 3560 switch and several VLANs configured on the that switch. VLANs are talking to my DHC...

I have a console server that I need to deploy in a remote cage that is only accessible by a long-reach SM fiber connection. I have a CIsco 2911 with a 16-port card for console connections, a 4-port switchport card for local connections and a SFP inte...

Topology Router (router on a stick) - Trunk Port - Layer 2 switch - Access Port - Layer 3 switch1 - Routed port - Layer 3 switch2 - Routed port - Layer 3 switch3 The complete topology is much more complicated, but I'm only detailing the relevant link...