Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi, we are planning to go with Cisco ISE VM appliance (our distributor prepared bill of material is mentioned below) for 100 endpoints. as per my understanding its a virtual machine and can able to install on vmware or hyper-v platform.   R-ISE-VM-K...

Hi, i have two  switch connected each other with a trunk. the first switch has ip 192.168.1.11 and the secondo 192.168.1.13.   The first switch has two trunk, one connected to the core and one connected to the second switch. The second switch has onl...

LN80 by Level 1
  • 768 Views
  • 4 replies
  • 0 Helpful votes

I am using a qnx computer with a Broadcom fiber card (1000 baseSX full duplex) connected to a C3850. The light on the switch port only flashes for a couple of minutes after rebooting the qnx computer, after that it stays off. I tried two ports and I ...

NetwkP by Level 1
  • 1306 Views
  • 7 replies
  • 0 Helpful votes

Hello All I a having a difficult time with what I thought would be a fairly simple set up but has stumped my limited knowledge.  I am including show command files for my running configuration as well as for ping results from both the router and switc...

lactoz by Level 1
  • 2182 Views
  • 7 replies
  • 0 Helpful votes

Hi Community Team,   I see log message in Cisco 9300-24-TA switch (with Network Advantage and Cisco DNA advantage subscription) sometimes and at the same time there is loss of connectivity with IPv4 or IPv6. Users are able to connect/ping to gateway...

Hello everyone  I have an issue  that PRTG not  read traffic for vlan in nexus  it stay to zero value when i        sh interface vlan 73 counters --------------------------------------------------------------------------------Port InOctets InUcastPkt...

we have a cisco router 2911 and 2 cisco catalyst 3650  the switch B is conected to siwtch A, and switch A is conected to Router, also we have a tp link 16 fastethernet, we have a survilliance system on our network, and we hve diferent kind of cameras...

Aquiles by Level 1
  • 807 Views
  • 2 replies
  • 0 Helpful votes

Hello.   Have anyone had issues with packetloss every 9 minutes 30 seconds?  Lasts about 10 seconds. Can be ok for a few hours and then it happens again. I figure it must be a spanning tree issue, but I can not make any sense of it. Example is: Asr90...

steinerik by Level 1
  • 661 Views
  • 2 replies
  • 0 Helpful votes

We are having cisco 981f router and two isp connections. Both isp connections are connected in cisco router.  I would like configure the load balancing. Pl suggest and share the sample configuration.   WAN connections - 2  LAN - One Ip segment   rout...

Hi we have two sites each have two 4500X in a VSS. These sites are connected via layer 2 trunks. We currently only run IPv4 over these two sites.Now we have a need to configure a VLAN to support IPv6 multicasting which needs to have MLD enabled and i...

ross_rulz by Level 1
  • 938 Views
  • 1 replies
  • 0 Helpful votes