Hey folks, I need to check which process is consuming the most amount of memory on the router. I used the "show memory processor allocating-process totals" command. The output is attached. The main-thread is consuming more than 13 MB of memory. But w...
Forum Posts
Hi, I wonder if anyone is able to assist with a HSRP issue I currently have . i have 2 Cisco 867 Router's with 5 vlan's on each. I am currently having issue with HSRP I am not receiving a HSRP "IN" on one of the routers. I have read various ar...
Below is the stack of 4500 as the top switch and 2960 switches. I have configured MST on all the switches. Backbonefast is too enabled. I have tried a number of combination of priorities on all the switches yet the convergence time of whole network t...
Hello,I have a very weird situation that I dont understand and need help with. We have a problem with a server that looses or cant reach its default gateway for quiet a few seconds and then it can reach the default gateway again. This can happen up...
We have a 3560 (12.2(25r)) which was installed a number of years ago. It has Nortel VoIP phones connected to it. the Phones marks signalling traffic with DSCP value of 40. this is re-marked to 26. I can see this in the qos statistics for the interfa...
Hi all, I need to implement Qos on cisco router. My main Aim is to restrict FTP traffic from external to internal. Please suggest How can i implement. I had two ISP configure on interface & need to restrict on both interface. then How can I do i...
we recently moved and I misplaced my password for my Cisco Router can someone please help me?
Does Cisco IOS routers support multiple instances for EIGRP IPv6 ? Is there any difference between the RFC and IOS ?
VDC on Nexus 3048 ? If yes, is there any impact on performance?
Hi, Im looking to configure Port channel between between a vPC peers in one location to a single Nexus in other location connected via dark fiber. Normal PC configuration as we do with any other Catalyst and Nexus vPC will work here? Need help
Hi, Is there any likelihood of a 40G module for the C4500x switch? Aidan
Hi,We have Nexus 5K switches at the aggregation layer and VPC domain has been configured on them. VPC domain includes switches at the access layer as an identity.But when primary switch reboots failover didn,t happened. We are attaching architecture ...
I net to force Gigabit ethernet port to speed 100
Hi, I am designing a new DC. In server zone of DC, I want to build a topology with Nexus 5k and Nexus 2K. Nexus 5K will be the VPC cores wheres as 2K will form VPC with 5K. 5K in turn are connected with firewall.All servers are connected to 2K in act...
Resolved! VTP Domain Name
Hello experts, Any input from you guys would be greatly appreciated. We currently have around 18-20 switches and all of them are configured as VTP servers. My colleague usually creates new VLANs on a switch with the highest 'configuration revisio...
