Hi All,
I have an odd issue with OSPF and ASAv.
If i create 3 ASAv's in serial I can get OSPF up and working with no problem routes pass all the way along.
If I try to connect a physical switch/router or an NSX edge device I get a very odd iss...
Hi,
Currently, I am doing the User Acceptance Testing for the Network which includes 2960x,3760x Series, Catalyst 4500x Switches.
I am doing this testing for the first time.
If anybody has experience on this, Please share with me the important testi...
Has anyone tried this on a isr4451 router?
According to cisco documentation , the buffer size need not be configured. What are the complications that the capture might not have been stopped and router run out of memory?
Another question I have is ,...
How Can I do to access a Nexus 9000 from different IP segment that currently the device is?
Do I need to create an ACL in the Nexus device to allow that?
Hi All, I have apic firmware different than for Spine and leaf, so APIC can't to discover the leaf and spine. i want to upgrade leaf and spine via cli using usb. can anyone provide me the procedure how to upload the firmware on leaf and spine then bo...
I have two nexus 7010 switches that I would like to add additional blades to. The problem is that in Power-supply redundancy mode, I do not have enough power with two 6KW power supplies. My power requirements would be a bit over 6.5KW. I do have add...
I've installed two spine Nexus 9504's, with two leaf 93180Y. I have HSRP between the two Nexus cores. I have one 40g connection to each Nexus core from each of the leaf switches. They are in vPC configuration. Everything is showing as it should. ...
Hello! I have a Catalyst 3650-24TD, running IPServices version 03.07.04E
I have a problem with router ACL containing object group: ACL is not working.WORKING config
ip access-list extended TEST deny icmp host 10.1.1.97 host 172.17.1.1 echo permit i...
I'm trying to understand the behavior of NetFlow in a VRF environment, or if possible at all. If I understand correctly, only one routing option existed for NetFlow export data packets. NetFlow sends all export data packets to the global routing tabl...
I have a router running ospf and BGP. I'm trying to establish the following behavior regarding the default route:If we learn default from OSPF neighbor, install in routing tableELSEIf we learn default from BGP, install into routing table and inject i...
Hi All,I have a below few queries regarding DHCP snooping. Please help to clear it. Thanks. Lets say my setup is lke this. I have PCs connected to access switch A (L2) with L3 uplinks to switch B (L3).From switch B I have routed path all along to my ...
Hi there,
Wondering if any of you folks can help me. I was recently working in the virtual space with Vyatta routers and wanted to move to a hardware solution using a 3550/3650 switch. I have an isue where I cannot connect to any of the networks se...
Which one is correct? If you know the correct answer, please let me know :)
When L4 recieves data from application layer, it saves the data in 64kB buffer. When 64kB buffer is full, L4 segments them, add L4 header, and send segments to L3.When L4 rec...
I would like to know with experts that does Catalyst 6807-XL-S6T-BUN (Sup6T with IP Services ONLY) support VSS?
I find different feedback from End Users on Cisco that Catalyst 6807 doesn't support VSS. So if it doesn't support that what is the alt...
