Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi everyone, I want to know whether cat3650 (IOS-XE ver 03.07.03E) supports WCCP redirection with GRE or not? I have configured a loopback interface and use it as WCCP source interface. The proxy server is located 2 hops away, and I am sure this is ...

randms2610 by Beginner
  • 1078 Views
  • 4 replies
  • 0 Helpful votes

Hello I have a question about how to get some Cisco 1841's with WIC 2T card's talking to each other. I have Packet tracer and I cannot figure out how to set this up and Have tried looking on the WEB for any information. Cisco end of life these yester...

roger by Beginner
  • 374 Views
  • 0 replies
  • 0 Helpful votes

Need some help getting this port channel enabled on my cisco 3560v2. I'm trying to connect  Dell VRTX server in a LACP LAG Trunk with Vlan tagging. Here is how the ports are configured. Cisco Switch Configinterface Port-channel1switchport trunk enc...

jasonw by Beginner
  • 3178 Views
  • 12 replies
  • 0 Helpful votes

Hello! I have two routers: Cisco 2921 and Cisco 3925. I want add secondary power supplies to it. What models of power supplies I must choose? Power supplies, that already installed in routers: 2921: PWR-2921-51-AC 3925: PWR-3900-AC If I understand ...

Hi, Can i configure port channel using different 10 SFP model (SFP-10G-SR-S,SFP-10G-LR-S),  switch 1 gig0/1 (SFP-10G-SR-S) --------- Switch 2 gig0/1 (SFP-10G-SR-S) switch 1 gig0/2 (SFP-10G-LR-S) --------- Switch 2 gig0/2 (SFP-10G-LR-S) Thanks,

Steev112 by Beginner
  • 4921 Views
  • 3 replies
  • 10 Helpful votes

  I am getting the Change of Authorization (CoA) Failed. Am getting this on all the switches configured for ISE   ISE Version : 2.1.0.474   Switch         Version          ROM C4506-E      03.06.03.E   15.0(1r)SG10 C6509-E     12.2(33)SXJ1 12.2(17r)S...

tlapite77 by Beginner
  • 651 Views
  • 0 replies
  • 0 Helpful votes

Hi All, I have spend a considerable amount of time trying to get me head around the QOS marking between the 3750 and the 3850. Basically please look at the configuration below, I have attempted to map the configurations from my 3750 to my 3850 but t...