Switching

I am trying to set up a network with a 2901 router. I added more ports with HWIC-4ESW but it is now clear to me these are not ip addressable as the router cannot assign IPs to them. So I ask, are there any HWICs I can use to add layer 3 ports? If not...

Been trying to get this to work for a couple of days without any luck. Trying to connecting two 3560's switches to a SM-ES3G-16-P switch/3925 Router. The First 3560 works fine (network 192.168.1.0), the second (network 192.168.6.0) I cant see on the ...

Hi all,I have a voice gateway and some phones connected to the same switch. The problem is: The voice gateway doesn't tag his packets for QoS, the phones do it automatically.Switch-HW: C3750-24TS-S1UVersion: IPBASEK9_12.2(55)SE4Qos is enabled and rew...

Hello guys, Your help will be very apreciated on this case. I am asked to shutdown unused interfaces, exemple bilow : Is there any way to shutdown intefaces when last input go above an amout of time ? Thanks GigabitEthernet1/1 is down, line proto...

Hello Cisco   I have an Export question regarding the Network Switch E-5000-12S12P-10G to be exported to Australia by Boeing for end use by a government entity.   On the Cisco Export website, the Network Switch is under ‘Self-Classification’ status ...

Hi, I have a setup, in which two servers need to communicate with a Router in a VLAN Segment. The challenge is that we have created a sub interface in the LAN interface of the Router with encapsulation dot1q 310 with IP address 192.168.10.1/24. The ...

Hello, i am having trouble getting 2 PC to ping each other on 2 differnent vlans that i have set up on my cisco 3750x there is vlan 10 - ip address 192.168.10.1  PC1 that is connected to this is 192.168.10.2 - 255.255.255.0 - 192.168.10.1 and vlan 20...

I need some guidance of how we can simultaneously achieve QOS classification with F3 and M1 cards on the same chassis. Knowing both cards uses different QOS structure, we are having issues in classifying traffic as those classification cannot be call...

Struggling w/ VLANs/VRFs in a virtualized environment and am hoping that someone can provide a little guidance.  My experience with VRFs is in a true MPLS environment, but VRF-lite is confounding me. The architecture is pretty straightforward:  estab...

Hi, Attached is the topology of network I have created. On R4 when I check the BGP table, it shows RIB failure. I tried to fix it but unable to find the issue. Can Anyone help. Thanks in advance. Outputs:  on R4 RTR4#sh ip bgpBGP table version is 2...

Hi Experts, Greetings!! I have few queries Regarding switching concept for more than a years still i couldn't find solution for that. Hope i will get solutions for those here. 1.what is maximum Physical switchports in a single switch ? 2.Does mult...

Hello  Community Please can you help me. I have my ISP that give me a new circuit with RJ48 of 155 mbps.(copper) My router is a 7200 with a GBIC WS-G5483 The Cisco 1000BASE-T GBIC (product number WS-G5483) connects a GBIC port to Category 5 wiring...

If using private addresses in my LAN network and a NAT on the router,How can outside hosts(on Internet) can ping my inside local(private address) hosts? thank you.

1) A networking device that plays an important role in directing network communication is called a Router.A) clientB) serverC) hostD) router In my opinion the answer should be Router because thats the only device in this list who is able to direct th...