Switching

I had a situation where I was getting a high rate of traffic coming into G1/0/12 on a 2960-X from an unmanaged switch.  This was getting flooded out to every other port on that switch that was in the same VLAN.  Here is a snippet of what I was seeing...

I am in need of purchasing several switches to sell to a school. I have looked at pricing through my usual sources (Ingram, TechData, DandH etc.) to get an idea of what switch will fit the bill best. I sometimes look at 3rd party sites as well to see...

Hola Comunidad Escribo aqui para saber si alguna posibilidad de configurar el flexible netflow para revisar una interfaz troncal de capa 2 en un Cisco Catalyst 6500 con el siguente IOS Cisco IOS Software, s2t54 Software (s2t54-ADVENTERPRISEK9-M), Ver...

Hi,I have 2 WS-C4500X-16's with enterprise services license, running IOS XE 3.4.1SG, in a VSS configuration.I have flexible netflow configured, conform to the software configuration guide, chapter 63, VSS environment.Contrary to what the configuratio...

Dear all I want upgrade my existing Nexus 7000 SUP1 to SUP2 , do I need to repurchase license for SUP2 (Chassis will keep , only upgrade Supervisor Engine Module) Thank You

Hi friends  Can we set username for enable in Cisco 2960 switch.i can able to set password for enable. But I don't know how to create user name for enable.

after execution command  request platform software package install switch all file flash:cat3k_caa-universalk9.SPA.03.07.04.E.152-3.E4.bin I've got not updated file packages.conf:iso   rp 0 0   rp_base        cat3k_caa-base.SPA.03.07.04E.pkgiso   rp ...

Hi all, I'm currently trying to upgrade ios-xe a 4-member stack of 3650 devices.The documentation discusses different ios versions being compatible or incompatible with each other, and how each configuration affects the compatibility of the upgrade ...

Hi Guys, we are planning to upgrade IOS of 3750 switches. Currently we are running 12.2(55)SE10. Could you please let me know which is the next suitable IOS version to upgrade.

I am experiencing inconsistent echo-replay from devices connected via VPC to Nexus 5500s while pinging from the Nexus exec prompt.In some cases I receive normal response when pinging from one Nexus,  but no response when pinging from the other switch...

I have a RV320 running firmware version v1.2.1.14.  The router is configured to run in gateway mode using DHCP for the WAN address. _ get the IP address from Comcast. Everything is working fine, but I'd like to get the DHCP lease information. Problem...

Hi There, I am doing some research on the spanning-tree mechanism. I understood that the spanning-tree 802.1d can be used in combination of the RSTP 802.1w. When two switches are sending BPDU between each other they will use the legacy STP BPDU if o...

Hello Everyone ,I have an issue with  switch 2960S stackable with IOS 15.2(1)E1 as the whole network is down and i couldn't ssh the switch. After reboot i got the SSH and I checked the log and i found the following msg:  %AAA-3-ACCT_LOW_MEM_UID_FAIL...

Hey guys probably an easy answer here but im not sure how to do it. I have subfolders for each switch in my tftp-root directory using solarwinds tftp. Usually I just do copy running-config tftp: I would like to include the folder so I do not have to...