Switching

Hi, I have my ASA 5540 configured with IP address 10.0.0.1/29 in the INSIDE interface and a public IP in the OUTSIDE. Connected to the ASA I have a Cisco Switch 2960 (L2) with 2 vLan's: vlan 230 (no DHCP) with IP address 10.0.0.2 and vlan 4 (DHCP)...

Switch: WS-C3560-48PS-EIOS: (C3560-IPSERVICESK9-M), Version 12.2(53)SE2I have the above switch running at a small site; it is configured as the default gateway (10.x.x.1 - has multiple VLANs) and also currently gets its own time from an NTP server ac...

Hello, I am trying to setup Cisco Campus Fabric in a lab. I have created border/core/edge levels with 3850 switches. My underlay uses EIGRP routing and each switch has a Lo0 that is reachable in the underlay. I have connected the underlay to my "ext...

Hello, I have a Gigabit port which is only negotiating half duplex. This is a service provider secondary WAN uplink spec'ed at 30 Mbps. They state that their side is set to full duplex but not sure what their speed settings are. I hard-coded to full ...

Dear Members, I am a newbie to Cisco products,  It is my first time with Cisco products ever. I need your help configuring my C881 K9 router recently purchased in order to connect  (ability to ping) my PC  (192.168.1.x) with different LANS  ( belong...

I have run into an issue. This is my first time using Nexus OS. I know that on my previous catalyst switches i could use show vlan to get a list of what ports were connected to which vlan.  43 VLAN0043 active Gi2/3, Gi2/11, Gi3/3, Gi3/11 Now on the...

www.cisco.com/c/en/us/products/collateral/routers/4000-series-integrated-services-routers-isr/datasheet-c78-732542.html The ISR 4351 has 3 x onboard LAN/WAN ports. I presume these ports can be turned into standard switchports (i.e. if I want them in ...

Hi, I am using Cisco 3825 router and 3750 switch in my network. My query about to use  public ip in  my lan client PC . I have two isp directly connected to my router both Ip address  block is /30 i have /27 public ips pool from one ISP and i want t...

I currently have a WS-C3560-24PS with SW Version 12.1(19)EA1d. The lowest version I can find on Cisco is 12.2(25)SE but the minimum IOS version needed for the upgrade is 12.2(18)SE. I am unable to find 12.2(18)SE. Any help would be greatly appreciate...

Hello, I have the need to send the logs from Cisco Switch to Syslog Server. I would like use kibana. Somebody used kibana with Cisco IOS before? Best regards,

I have an ASA that is solely being used to attach to AZURE's VPN If i attach to the inside network and use 10.0.0.13 as the gateway i can get onto the vpn network.  I'm trying to add this to our core network but the OSPF routes are not being showing ...

Does IOS on catalyst switch support LDAP authentication for CLI admin (exec) login ? I've checked numerous configuration guides, but couldn't find a clear answer. I see Radius is supported. Thanks!

Hi, I need help, recently in one router in our company the following issue occurred: %DUAL-3-INTERNAL: EIGRP-IPv4 I found information that this is software issue and IOS should be updated, can anyone advice what to do? Thanks in advance.