Hi,
I am looking for CIS Security Configuration Benchmark for Cisco Switch WS-C3650-24TS-L, with IOX-XE cat3k_caa-universalk9.SPA.03.06.06.E.152-2.E6.bin.
Anybody has this reference?
Hi all,
I have configured default port-security configurations on the switchport where the hosts are connected.
int e0/1
switchport mode acc
switchport acc vlan 20
switchport port-security !! First I configured this, port goes to err-disable
!! t...
I have two switches, switch01 and switch 02 is both connected through f0/1, switch01 is 2960 switch, switch 02 is 3850 switch
switch01# int f0/1, sw mo tr ,
int f0/2 sw ac vl 10,
int vlan 10, ip add 12.12.12.1 255.255.255.0
switch02#int lo0 ip 2.2....
Hi Gurus,
This should be easy for somebody I hope. I have implemented ARP inspection and am getting some printers that seem to be sending ARP replies to themselves. It doesn't stop them from working but does create annoying log messages. Any idea ...
Is there a way that you can configure a 4500X VSS stack to automatically failback to the primary switch after a secondary switch failure or upgrade. I upgraded the IOS on a 4500X VSS stack and reloaded the secondary switch first and then the primary...
This is a lab i'm running at my house. I have DISTRO1 & 2 running HSRP for several VLANs. DISTRO1&2 are connected to CORE1&2 through routed ports. My management subnet is 10.1.99.x. From CORE1&2 I can't ping all the SVI in DISTRO1&2 nor their managem...
I am currently working to design a hybrid IWAN network between three sites. We currently have at each site 2 edge routers for MPLS (peering to a primary ISP and backup ISP) and two edge routers for INET (peering to a primary ISP and backup ISP). We...
hi all,
As we know, once we implement this command under this eigrp interface,it will suppress more specific IP block been advertised out to eigrp neighbor.
for example:
Eigrp 100
R1-interface gi 1/0--------------- int...
Hi there,
Thanks for reading!
Remote users complained of losing all network services. Here's an ASCII "diagram":
Router1 <-> CoreSW1 | |Router2 <-> CoreSW2
RT1 & RT2 are confd as an HSRP pair.
RT1 reports Late Collisions at the time of the ...
Hi,
Is it possible to have an interface that is both a destination in a local SPAN session and a destination in an ERSPAN session?
So for example I have Switch A and B. On Switch A G0/1 is destination in a local monitor session and is also a destina...
Any thoughts on this? Having a strange problem. On some of our newer 4510s (SUP 8e), I'm having some devices not getting dhcp addresses until I take off port-security.The background: on at least two 4510s, new installs, everything comes up and wor...
