Switching

1) A networking device that plays an important role in directing network communication is called a Router.A) clientB) serverC) hostD) router In my opinion the answer should be Router because thats the only device in this list who is able to direct th...

Hi there, What is best practice to remove a chassis module such as fwsm or wism ? Is it to shut it down and remove the card? If you shut  it down by not allowing power to the line card, does the card get power on next start up/ Also configuration...

what is the difference between the arp & mac address table    pc1====switch====pc2 how the process is going to form arp table and mac address table  to ping pc1 to pc2 what is the relation between them

is my device compatible to SFP 10gb SW-C2960X-24PS-L 

I am looking at getting some advice on extending my network with an amplifier or booster? At the moment I have a Cisco AIR - CAP1532I - E - K9. The cable to the Cisco AIR-CAP1532I-E-K9  is pretty long already, what would be the best to do this? Tha...

currently i have fc1/15, fc1/16...fc1/19 with switch port mode NP in my switch a , if i use sh cdp neighbor, i can't find the storage switch connected, how to identify storage switch connected and the port name connected to NP port (fc1/15...)

i try to change the mode of spanning tree to mstp and i lose the conenction how can i avoid that? 

Hello, I recently took, and failed, the CCNP SWITCH 300-115 exam, one reason being a section on one of the sims which completely baffled me. But since then I have been researching this and cannot find any other way of completing it than the method w...

I have 2x3850 stack connected via fibre . But 1 link has gone not connected sometime back. I did a shut/no shut on sw01 Te1/1/2 . It showed connected and then went down again. sw01 Te1/1/2   sw03_gi1/1/1 connected    trunk        full   1000 1000Base...

i  have 3640 router it is powered on getting romman 1 > how to solve this problem

i have heard 3 types of packet witching. 1.process switching 2.fast switching 3.CEF by default which is functioning in a switch

Are broadcast and multicast limited to subnet ? 

what is the difference  between broadcast and multicast 

I am trying to install an old version (6.2.5) of DCNM on a windows server (32 bit OS). the install starts fine, but after I enter a db password, I get an error about port 1100 not available. I run the port refresh and update the ports, but still get ...