Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

today i checking to my Nexus 7k switch and i find a problem %MODULE-2-MOD_SOMEPORTS_FAILED: Module 10 (Serial number: JAF1813ALCH) reported failure on ports Ethernet10/13 (Ethernet) due to unsupported port speed config in device DEV_PORT_CLIENT (dev...

Just to ask you because the 1941 cisco don't accept the default credentials after I put the following script Config t Hostname xxxxxxx Enable secret heri1 Line vty 0 4 Password heri1 I rebooted the router and once it came back it didn't accept the ...

hatienzo by Level 1
  • 570 Views
  • 8 replies
  • 0 Helpful votes

HI ! I do not have a fault but my logs are full of RP messages as follows - my objective is to get rid of these as they are annoying !!!! Any help be appreciated ! 3641169: Jan 10 12:36:40.851 GMT: %PIM-1-INVALID_RP_REG: Received Register from rout...

hi , i have one question , i have Cisco switch 3750 G , and i need configure one physical port to connect 2 Vlas , in details , i need connect physical server (192.168.0.4) , and Virtual( Hyper V) on same server (192.168.1.4) . in  details please

LinkedIN by Level 1
  • 1093 Views
  • 6 replies
  • 0 Helpful votes

Hi, when i try loggin by HTTPS on a router i have next errors.%HTTPS: http ssl get context fail (-41104)HTTP: ssl get context failed (-40407)I have a 2821 router with c2800nm-advipservicesk9-mz.124-15.T1.bin iosCan anybody help me?

I'll start simple and I can expand from there, based on questions asked.  I hope to get some good idears... 40,000sq 1 level building. Modern openconcept plans They like to hide all cables and do clean runs. No budget talks, we're private so it can...

Hello I have two switches connected together. Switch#1 has it's interface as an ACCESS port (VLAN 31). Switch#2 has it's interface configured as a TRUNK (allowing VLAN 31 and VLAN 41 with native VLAN 1) n.b. native VLAN 1 SVI is disabled so it cannot...

Suppose there are two routers that run EIGRP and are interconnected by an L2 switch. Is there a way that neighborship can be formed between these routers.If yes, how?

grapevine by Level 1
  • 1072 Views
  • 6 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card