Switching

We have an active/failover ASA pair supporting WCCP which redirects Internet bound traffic to WebSense appliances for proxy/filtering services. As recommended, WCCP is redirecting inbound on the “inside” interface and is currently fully operational. ...

Hi, I want to know what will happen to Cisco 4507 and 3850 switch, if temperature goes above its operating temperature i.e. 45 Degree Celsius. Will the switch gets shutdown or keep on functioning normally?  Similarly, what will happen if temperatu...

I have four (4) Nexus 5548UP switches which currently have System Version 5.2 (1) N1 (3). My question is can I upgrade them directly to System Version 7.0 (8) N1 (1) or is there a process and I have to start with a previous version before I go to 7.0...

Hi. Just bought 3 Cisco 2811 routers and 7 IP phones 7960 from ebay and tried to follow this guide, but failed: https://www.youtube.com/watch?v=6rQakFGMZRM The problem is that 2811 doesn't understand/accept the command "telephony-service" - any idea...

Hi . I have 3 VLAN on my network . 192.168.20.0/24  gw=192.168.20.1 192.168.22.0/24  gw=192.168.22.1 192.168.24.0.24  gw.192.168.24.1  inter vlan routing  is enabled and access list create some custom access list for communicating between hosts  .no...

Hi, we saw a weird issue few days earlier. we have a SPAN Session on 3850x which has 1 Destination Port Lets say port number 20. this Span session has ACL Filter applied to only capture data from 192.168.10.0 to any. So we bought a new sniffer server...

Model Number : SG220-50PID : SG220-50-K9VID : V01Cisco Sx220 Series Switches Software, Version 1.0.0.19BOOTLDR: Sx220 Boot Loader Version 1.0.0.6 We have two Cisco Switch SG220-50 on our Server LAN. They are both on different ports I get the followin...

Hi, what are the differnces between C6800-32P10G-XL= and C6800-32P10G= DFC4XL and DFC4 ? Does it suite in cisco C6807-XL (M8572) Thanks

Quick question. The client I'm working for has a Nexus 3064-T switch, which will soon be end of life.  Is there a requirement that to create a VPC pair with another N3K switch, it has to be the same model, or would they be able to purchase, say, a N...

I am unable to ping from my pc to the vrf gateway.  The pc is directly connected to the gig0/2 interface.  The pc was assigned an ip address from the vrf Student pool.  I can ping from the router to other connected routes in the Student vrf. R1#pi...

Hi I think WS-X6904-40G has oversubscription mode and performance mode.When I change oversubscription mode to performance mode and vice versa,does switch need reboot or module rest ? Regards, shige

Hello guys, I have an issue two C3850 switches. One of C3850 is in the production and operates normally - second one I am adding to the production. Previously those switches were stacked - however I DO NOT want them to stuck. I want them to operate ...