Switching

Hi everyone,I am quiet new to packet tracer. I am currently having trouble with creating an access control list for my packet tracer file. I am aware of the deny and permit commands, but not to sure what 2nd IP address should be used at the source of...

Dear All, I have been facing an issue where users complains of not getting an IP address from DHCP server although i have done all the necessary configuration and checked multiple times. I am using 3650 switch with built in wireless controller for my...

Hi, Can you please advise if any intermediate upgrade is required to upgrade from 12.2(52)SE to 15.0(2)SE8? TIA PF

Hi Team, We are changing our dhcp address an i need to change my dhcp relay on all my vlan but what is the command to remove the all dhcp relay on the vlan. This is my vlan  interface vlan10 ip dhcp relay address 192.168.100.42   I need to remove th...

Hi all, Just wanted some advice on the best way to troubleshoot ACL's on an ASA.   Yesterday while configuring our VPN to AWS, i added a permit ip any any onto the end of an ACL to avoid the implied deny, however it dropped all external (internet acc...

Hello team, Not sure if this question has to go to Unified Computing also. I´d appreciate any advice. Customer is running Hyper-V on top of UCS (actually, UCS is part of a Vblock, but VCE/EMC don't support Hyper-V). Everything runs just fine but the...

We have been using VLAN 1 forever as our device management VLAN. In trying to move off the native VLAN and into what I have been told is best practice, I am trying to setup switch IPs on the management port, on my 2960 devices it is F0. I created a ...

Good afternoon everyone, I have a Cisco switch 2960s-24PS-L that has come back from a closed location. I am trying to wipe clean the system so it can be used again. I went to bypass the password I found the the flash directory is empty no IOS, config...

Community I have a switch catalyst 2960-X series, to which I connect two access points that support Up to 100 users each. I have connection problems since the access point loses connection momentarily In the documentation of the switch each port ...

Hello, This is an issue we seem to have and I am hoping someone may have seen it before. It is a very random issue, I cant replicate it, it doesn't happen often, maybe 4-6 times per month. Network background: Layer 2 switched network (VSS). 2x core ...

Hi, I've attached an extra router to a CISCO RV320 a bit like in this diagram.The RV320 is 192.168.1.1.The new router gets a 192.168.1. WAN IP from the RV 320.The LAN IP subnet new router is 192.168.2 So far so good, that works as such, BUT... In co...