Hello,
on my router 4000 with IOS ver 15.4(3)S4 I cannot find the usual command
standby 1 track interface
I can only find standby 1 track obj#
which is the new procedure to track an interface?
Hello,
Please can you help, I currently have a site to site VPN router (Cisco 887) and i want to create a separate LAN on the router to route everything which isn't needed on the VPN (basically raw internet).
Can someone explain how I would go abou...
I would like to know the packet drop issue. I am facing the packet drop issue on network since one month on morning time from 8:39 AM to 9:10 AM.
if you have any idea please share with me.
Dear All,
I am facing below error in 2960-24tc-s switch
!!! WARNING: The switch is not usable !!!Reason:Error unsupported TCAM value sizeActual value = FFFF, Expected value = 20
I deleted the preloaded IOS and load various old and new version of IO...
Hi everyone, need help with router CISCO2951/K9 IOS : boot system flash0:c2951-universalk9-mz.SPA.155-3.M2.bin with telephony service. it is reload itself periodically crash info showing
"Unexpected exception to CPU: vector 1400, PC = 0x9AD2C34 , ...
Hi My predecessor had installed 2XCISCO 3750 switches 24 port (implemented LACP on these core switches), we have 4 Comms cabinet on different floors up-linked through fibre to the core cisco switch and all the 4 cabinets have a mixture of D-link, HP ...
HelloI'm trying to disable the password recovery service on a router 2921 and does not accept me "no service password recovery"someone could tell me how do I have to do or command ?.
Hello,
I need your help in one case.
I have a switch (c2960s-48FPD-L) and I want to configure the macro into it.
Can you please tell me why if i write "macro ?" the only option the switch give me is "auto and global"? How to get "macro name" ?
I nee...
I have a 4431 router (For use as a SBC) that I would like to resiliently connect to two 2960X switches.
Is there a way I can do this at layer 2, or do I need to do it at layer 3 via routing and the loopback interface?
Thanks,
GTG
An external Log system notified about: An ospfIfAuthFailure trap has been received for router y.y.y.x, the interface is y.y.y.z and the error is AUTH-FAILURE.This to IPs belong to a mutual PortChannel between these 2 devices.No logs found on my devic...
Dear all,
I have a question regarding the BW allocations for ingress queueing on Cisco 3560 switches.
Assuming that the configuration is as follows:
!
mls qos srr-queue input priority-queue 1 bandwidth 20
mls qos srr-queue input bandwidth 3 7
!
...
Hi All
I have a pair of Failover ASA5520's, with the following interfaces:- Outside- Inside- WAN- Management
Both the primary and secondary unit each have a physical connection to the other end device apart from the WAN interface.
The WAN interface o...
Hello,
I have a cable modem connected to a cisco 1841 router which i want to do NAT on. I cant get the NAT overload to work. In the show ip nat translations it appears my outside global and outside local IP addresses are incorrect. Has anybody seen t...
