Switching

I have an older switch which does not support Layer3 Ports (routed port).  can I connect this switch using an SVI with another switch where the interface is configured as a routed port ?    

Hi All, I understand that the Cisco Nexus 9396PX switches does not currently support dual homed FEX. Does anyone know if this feature will be supported in a future NX-OS release? Thanks 

*Please refer to the attached topology. To eliminate single point of failure and provide redundancy, usually we configure HSRP at the gateway that is usually a L3 switch or a Router. On ASA this feature is not supported, so how to configure the ASA a...

Hi all, I have encountered a rather strange issue last Friday with a Cisco 866-vae-k9 router. My monitoring system informed me that I had lost the ping to the WAN interface and after a quick troubleshooting it appeared that the router was not respon...

I've been playing around with multicasting with the 3750G switch and I've notice some packet loss with multicast streams. So the basic setup is as follows: Host1 (in VLAN1) <-----------> [ 3750G Switch with IP services ] <------------------->Host2 (...

Team, Any one of you have tried to configure dhcp server on WS-C2960+24PC-S switch. 

Dear All, I have a wireless guest vlan.. we do not want it to communicate with other vlan's. how to block this communication. can anyone please advice the configuration steps

Greetings, Have anyone ran into this problem?  I established a fiber trunk from switch to switch. I can ping switch to switch but not the end users.  However, when I create a trunk through normal Cat5 everything works fine!  Any ideas? Thanks.

I have a network at work made of cisco swithes and routers. The problem is that employees connects the fritz box to get wireless access to the network which results in lot of issues in the network. Is there a way to block this device from establishin...

Need my thinking verified...If I dual home a device directly into 2 5000 switches in a vpc cluster, I can run active active LAG uplinks, right? But how about if I have that same device uplinked to 2 FEXs which are then uplinked to the same 2 5000 swi...

Hi, I need your help in understanding fiber module on 3850 switch. I have recently added fiber module on 3850 switch and I can see below ports visible after adding module. Cant I use all four TenGig interfaces as uplink ports for 10Gig connectivity ...

Hi All, As Nexus 7K platform doesn't support multihop BFD so i have to use faster the BGP hello and hold timers. When i try to configure BGP timers to "timers 2 6" (hold time = 6), i get a warning message as below "% ISSU will be affected if hold ti...

Hi Team, I am reeving this error in switch. please explain. %SMN_HBL_LICENSE-1-EXCESS_AP_LIC: MEMBER: 7 stack-mgr %STACKMGR-1-STACK_LINK_CHANGE: MEMBER: 6 stack-mgr:  

Hello Everyone We in DC we have a primary MPLS circuit and a less expensive point to point VPLS type circuit.  We identify all of our replication traffic via acls and route accross the point to point.  Most ACLs are pretty granular which have source...