I am looking for the latest recommended IOS release for a Cat 4500X L3 switch. I am currently running "Version 03.05.01.E RELEASE SOFTWARE (fc2)" which I believe is a couple years old. I also need the upgrade instructions. Thanks.Aaron
Hello,I have the following test setup in my lab [Motorola Set Top Box (STB)] <----> [Residential Gateway (RG) ] <----> [Cisco 3750 Switch g/34] [Cisco 3750 Switch g/44] <---> [Microsoft MediaRoom Server switch (MMR)] When changing channels, the STB r...
Hi guys, I have a quick question on the C3750 switches. Lets say I have 2 switches stacked together for redundancy, meaning Server A has connection to Stack A and Stack B.I would like to upgrade the firmware of the stacked switches. How do i ensure w...
I have a Cisco Catalyst Switch WS-C2960-48PST-S, and I cannot modify the flash content, I can´t create any VLANs or save the config.
Here you have an output trying to create Vlans
Switch(config)#vlan 10
Switch(config-vlan)#name VOICE
Switch(confi...
Hi, I have a switch stack that has 4 3750X switches and three of them have the SFP module C3KX-NM-10G. Which two ports are the 10GB ports and which two are the 1GB ports? I have tried to figure them out, but so far no luck. There are 4 ports,1-2-3-4,...
Hello ,
I have an issue or it is not an issue more than strange configuration ,I have 7200 router reloaded unexpectedly after the reload I can see under a specific interface "negotiation auto" command despite of the interface is hard coded.
int...
I am looking for the latest recommended IOS release for a Cat 4500X L3 switch. I am currently running "Version 03.05.01.E RELEASE SOFTWARE (fc2)" which I believe is a couple years old. I also need the upgrade instructions. Thanks.Aaron
HI guys. I have like this diagram : [routerA]----{Internet_MPLS}--------[routerB]----[core_swB]----[access_switchB] network , where some users on vlan 500 on access switch_B saturate internet pipe (there are other vlans we don't need to touch )...
hi,The bandwidth % value you can configure is <1-999999> !How it is possible to configure 999999% bandwidth utilization of an interface? any value above 100%, what is the use cases for it!
I created an extended access list and allowed a single mac address in a conference room, so only the VoIP phone will have access with a deny any any at the end. It did not work, so I removed all permits from the list and just have a single deny any ...
Hello Everyone,We have Cisco CISCO1941/K9 router and we want to configure IP SLA on this router but router is not accepting commands.Router is running with c1900-universalk9-mz.SPA.150-1.M1.bin IOS which is already differed release on Cisco site.Als...
I have Packet Tracer 6.2.0 installed on three different computers and it crashes on all of them while I'm using it. While I'm doing different configurations all three will crash within 5 to 10 minutes. Is there a DMP. file that I can capture or retr...
Hey guys, I have been working on a few ideas but dont really want to break a current live network. I am looking for a Cisco Virtual environment, mainly switching as we are not configuring routers at this stage. Does anyone know where i can download s...
I have HSRP setup on a two Cisco 4510 switches (VLAN 199). I can only ping one of the physical IP addresses (.2), while the other (.3) returns a Destination net unreachable. The vlan has no ip redirects on it and I cannot seem to get that to go aw...
