Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

I am trying to configure 802.1x RADIUS Authentication on cisco 2950-24TT-L Switch. I am using following set of command as given below Switch# configure tSwitch(config)# aaa new-modelSwitch(config)# aaa authentication dotx default group rediusSwitch(c...

Hi. I was switching my AP infraestruture from 1231 APs no the new 1702i. They are under WS-C2960+24PC-L. The AP doesn't boot. although it turn on, it keeping the red led state.Any thoughts?Cheers sw02#show int statusPort      Name               Statu...

Can someone please explain what each of the following commands does? aaa new-modelaaa authentication login default group radius localaaa authentication login CONSOLE localaaa authorization exec default if-authenticated Also what relation does the com...

Hi all, I have been googling , but mostly they talk about how to setup Access point but did not mention about how it actually works internally. q1) Can I just think of AP as "wireless L2 switch"  which also bridge the radio signal network to the wire...

SJ K by Level 5
  • 4702 Views
  • 4 replies
  • 0 Helpful votes

Hello,i have a cisco 2960x series switch, this has been generating high usage of cpu, this is the output of show proc cpu sort 5sec command:CPU utilization for five seconds: 61%/27%; one minute: 61%; five minutes: 70% PID Runtime(ms)     Invoked     ...

Hello @all cisco specialists,I've a serious question relating to my Catalyst WS-X45-SUP7L-E running IOS-XE Release 03.04.04SG with EntServices.I just checked the Cisco software/feature navigator for network address translation in IPv4.Is it really tr...

Hi,Can anybody share your experience of upgrading cisco 2960 XR (WS-C2960XR-48FPD-I) from 15.0(2)EX5 to 15.2(3)E1.Have you got any problem after upgrading?Any issue with stacking /CPU load/memory utilization ect?Do you recommend to go for 15.2(3)E1 ?...