HelloAbove Mentioned Subject Switch Hanging Issuesee Sh log,Sh Ver,Sh run logs are availble.I have checked out but no any problem seenif anybody see and provide valuable suggestion. Bharat
DearsI have 2 no's 6509 chassis in VSS with sup2t and ASA-SM installed, as I know that the dataplane is active for both switches so the cisco says that I we will get the throughput of 4.0 tbps but the ASA-SM only supports 20 gbps, and all vlan interf...
Hello,I have enabled port security on switches with below configuration. I connected guest laptop in switch A and completed my job and kept my laptop in IT cupboard. After 10 days I took the guest laptop and try to connect on switch B in same vlan, ...
Hello all,I've got a problem, I've got two sites witch are connected with ASA 5505. Both are connected via a VPN.Site 1 and Site 2 (Site 2 is connected via a modem to the internet).The network from 1 and 2 are connected and see eachother. From site 1...
If you were connecting a 5555x to a 6500, would you use a single port channel with 8 uplinks, or two 4 port etherchannels, with one representing the "out" and one representing the "in" I intend to use ten or more contexts, and in the past have done t...
Hi, all, I've run into a problem and I'm not sure what I'm doing wrong, so hopefully one of you experts can point me in the right direction.I'm installing a new Cisco 2911 and wanting to configure G0/2 as a dedicated interface for management. Our ma...
Can someone shed some light on the following N7k EIGRP command:{ip | ipv6} offset-list eigrp instance-tag {prefix-list name| route-map name} {in | out} offsetI have two neighbors connected on the same LAN segment/Interface VLAN. Right now I am learn...
I have two sites that have a fiber run between themim using a sg500x 48p andsg500 28 p they both have a MFEFX1 module ive put the mfefx1 in the xg3/s1 expansion port on the sg500xand on the s500 I've put the module in g27/s3 port. first question thes...
I got one side of my lacp port channel down. the topology is shown but the left side is showing down 20 Po20(SD) Eth LACP Eth1/5(s) Eth1/6(s) # sh int port-channel 20port-channel20 is down (No operational members) Hardware: Port-C...
Hi allWe're in the not very comfortable situation that our WAN service provider will accept only a very small set of DSCP values to assign traffic to their "Classes of Service".Our 2960s are directly connected to the carrier's CPE, and on that link w...
Our network consult has recommended we purchase 2 x Cisco Nexus 5548P to replace an existing Catalyst 3750G stack. Do I need to ask the supplier to quote for licenses as well as the hardware? If so, what are the options?If we don't buy licenses, can ...
HiI have edge switches connected to core switch using trunk. We have attached cisco Ip phone to end switches , we are going to deploy QOS . As below we implemented auto qos voip cisco-phone under cisco access switches interfaces and under trunk we di...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
.png "Hall of Fame"){kind=icon}