Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

HI all,I have a couple questions about upgrading the IOS on our WS C4507R-E.    We have 3 installed cards: 2 WS-X45-SUP6L-E supervisor modules running 12.2(54)SG  * running Active/Standby1 WSX4606-X2-E 10G cardROMMON is currently at  12.2(44r)SG5 I'm...

hi as per research fabric extender for nexus 7706 only have edge port support. we cant connect a layer 2 switch with a fex. we were looking at N2K-C2248TF. so now question arise does these cards support all sorf of vmware technologies? as we know som...

Hi All,I'm looking if anyone can help me in determining the root cause of a crash starting from the attached Crashdump file.Any input would be much appreciated.ThanksDario

We have 4507 R+E switched installed in our network. For the past 6 months, we are observing temperature warning in Module no. 3 in the CPU part.I want to know why this is happening. We take out the module clean it with a blower and the warning disapp...

To establish the ospf stub area between the distribution switch with the core switch or ABR. Do we need to set the static route on the distribution switch to point the  ANY to the ABR/core switch gateway?I read the article that the default route is g...

I have recently joined a company, and they  have below network topology.There are these vlans defined with Ip routing enabled.interface vlan 4name "Four"routingip address 192.168.4.77 255.255.255.0exitinterface vlan 10name "Infrastructure"routingip a...

I have recently joined a company, and they  have below network topology.There are these vlans defined with Ip routing enabled.interface vlan 4name "Four"routingip address 192.168.4.77 255.255.255.0exitinterface vlan 10name "Infrastructure"routingip a...

Hi all,I have 4507 R+E installed. As usual one of its supervisor module is in "Active" state while the other is in "Standby hot" state.I want to know how to make the standby supervisor as the active supervisor without shutting down the switch or with...