Switching

Greetings,We are trying to troubleshoot a Cisco Catalyst 6506E 720Sup switch. When powered ON, the switch keeps getting into Rommon mode.I have tried the recovery procedure using the s72033-ipbase-vz.122-33.SXI2a.bin on the bootflash:. Any command I ...

Hi, For some reason when I ran the command test cable-diagnostics on some cisco 3750x the test never complete. Here is the command:test cable-diagnostics tdr interface gigabitEthernet 1/0/44TDR test started on interface Gi1/0/44A TDR test can take a ...

Friends , I have one question please . in Nexus 5596T Switch the 32 fixed 10GBASE-T ports does it support both 1 Gig and 10 Gig or only 10 Gig ? Please advice ! Thanks in advance ...

Hi,We have in production a stack consist of 2 x 3750 switches - ie a 48 ports and 24 ports with same IOS & version.The 1st 48 port switch is the master with port 1 uplink to a router and 2nd switch is a 24-port slave .if we remove the master switch (...

Hi.. i have been running nexus 5548 and looking for implement ospf. But not sure whether it support advance ospf routing. Pls tell me whether ospf would run on this switch with all its advance features. Software  BIOS:      version 3.5.0  kickstart: ...

I plan to buy SmartNet for my Core Switches 4503-E that has:Mod Ports Card Type                                                  Model              ---+-----+-------------------------------------------------------+------------------ 1     4  Sup 7-E ...

Hi,Is it possible to shape and apply queuing mechanisms all in one policy-map out of an 4500's interface ? Thx

Dear All, I am using a Cisco 1941 router with IPbase image .I am not able to configure NAT-PT on this router.when I type ipv6 i am not able to see the nat command after that.Do I need to do something different.ANy suggestion here will be helpful.Enst...

Hi all,just asking, any one knows if its possible to configure an 10G interface from a network module in a 3750 X switch in ACCESS MODE?

Hi,allWhen we deploy PPPoE in our network, the "ip mtu 1942" command is necessary to be typed on the outgoing virtual interface.To find the reason, I had done such a lab as shown below.(1)Topology(2)ConfigurationPPPoE was deployed between R2 and R3 w...

We are currently using 2 Cisco 7201 w/ NPE-G2 pushing about 1300-1400 PPPoE sessions via L2TP tunnel on each.  Each device does about 850Mb/s throughput.   In total we have around 2700 PPPoE sessions with a total of around 2Gb/s bandwidth.  We provid...