Switching

HiConfigured PBR in Cisco 3850 ,But i can't find policy route map in my interface. route-map test1 permit 10 match ip address PBR_server set ip next-hop verify-availability 10.3.2.1 1 track 1Core_IDC3850#sh track Track 1  IP SLA 1 state  State is Up ...

Hello Everyoneactually i have two Cisco 6509E with two VS-S720-10G and want to run VSS on themi do all the config same as cisco recommend, but i get somethings wrong on them, 1st. on switch2 , under "switch virtual domain" when i enter switch2, its n...

the Goal i'm trying to achieve is having a Cisco outer 2801 (which is the internet ip: 75.150.67.105) open a port 3001 tcp to give internet to another cisco device with a IP of 172.16.8.40interface FastEthernet0/0ip address 75.150.67.105 255.255.255....

Hello, I am getting these warnings on Cisco 2960 switches that connect up together using multi mode fibre. The cables are no longer than 150m between the switches. The switches are using GLC-SX-MMD SFPs. The warnings: %SFF8472-5-THRESHOLD_VIOLATION: ...

i try to make link aggregation group between Cisco sg300  switch. In these switch between two link first POINT TO POINT LINK and second link fiber optic.Both link active but when i shut the port of fiber optic then communication has been stop on the ...

I have 2 hosts connected to the same switch. Each host it set to execute an FTP at 9000 BytesSwitch ports are both configured for 2500 Bytes What happens when a 9K byte frame is received on the switch interfaces? They drop them, right?

I have been placed into a network role for a customer while my expertise is much more desktop / server oriented.  I do have my CCENT and have been working on the CCNA so I am not completely lost, but I cant figure this out and the deadline is approac...

What is the Best Switch to use with 2-4 10 gig SFP+ uplinks and gig ethernet interfaces?I have looked at the 3850 Series switches, 4900 series and the 3900 series. any ideas would be greatly appreciated

Hi,I have a question about how to influence the routes learned from a specific EIGRP neighbour. We have one multi-access vlan with 2 core switches and 2 routers. Switch A and Switch B have the same routes (shared VLANs). Router A and Router B have al...

Hopefully this would help to all of you that have packet loss or TCP retransmissions, due to the fact that the ARP timeout is an absolute timer and not an activity timer like the MAC Address Table Aging Time. This is an expected behavior in this type...

 Having issues  with new core on 7710's upgraded from 6.2(8a) to 6.2(10) running ACL's on all SVI's, Netflow, and DHCP Snooping with one VDC added along side the admin VDC with 2 F348 line cards and dual-sups.  The 6.2.10 upgrade was due to TCAM erro...

We just got installed a METRO LINK between our primary and secondary data center (Site-A <> Site-B) I would like to be able to route data replication between these two sites over that link, instead of going over MPLS.  We run EIGRP internally and BGP...