Hi, I have Cisco switch 2960 (WS-C2960+48PST-L) switch. I want to connect 48 ip phones 802.3af standard based.will it give power to all 48 ip phones through its Poe ports?
HiI have C3750E switch, and it is in stack. I am managing both the switches with management interface fa0, which is for Master switch in stack. But while I check for management interface for Slave switch using show int des, I dont see any interface f...
Hey - I applied auto qos to a new 3850 but, I don't see the long list of MLS config that I thought it would generate like the 3750s. Is this hidden config in the 3850 now? I'm in the middle of reading the 3850 documentation but, I thought I would thr...
We were working on enabling multicast over our wireless network. We were struggling with getting the end points to communicate. After talking to Cisco TAC and another wireless specialist we were told that we needed to enable pim on the access vlan ...
Currently, i have an Cisco IE3000 switch, with an interface defined as a trunk. The other end is unknown to me, but I know it transmits tagged frames. I just don't know which VLAN-ids are in use - so I was thinking on doing some debugs to learn the V...
Hello, We need to order a new small Cisco Router for a very small branch office having max 10-users.We need the following features be available of the router >-IPsec VPN feature support-Wireless support Can anyone advise which exact series I should o...
Hi all , we have a network with CORE4507 access 2960x24port+4portSFP CORE configured to allowed vlan all till access switch SFP interface Gi1/0/27 when i show log to switch i found error below. \%SW_MATM-4-MACFLAP_NOTIF: Host 4025.c225.d9f0 in...
Hi hope someone could help?I'm trying to get a DHCP to my Guest ssid from my access point.The Thing is that when i connect to SSID 1 i get DHCP from VLAN 1 and that ok.When i connect to SSID 2 Vlan 2 no DHCP at all.AP:Operation Mode:Multi ssid Enable...
UPDATE:I did it - uploaded the modified configuration files to startup-config and scheduled a reload. Everything came up and is working correctly.I only have one thing that didn't go as planned: One of the N7Ks that ran two VDCs lost config to VDC id...
Hello,I've configured my old Cisco 2600 router to act as a DNS server for a LAN. My clients successfully resolve internal hosts and external hosts just fine but I have noticed that the router will forward dns queries to our external DNS server for i...
how do you improve performance of Cisco HWIC-3G-HSPAcurrently i'm using a Cisco HWIC-3G-HSPA card on one of my network Routers however Link is too slowwhen i transfer a big file (100MB) across link connection starts timing out is there a way i can im...
Hi, The ASA5515 isn't detectng eigrp routes. I have checked and rechecked and can't seem to figure out what the issue is. Below is the output for troubleshooting. Why is it ignoring multicast?router eigrp 101 neighbor 10.10.YY.3 interface ENS neighbo...
Is there a way to lockdown SNMP traffic so that it only transmits on a VLAN ? I have catalyst 3750g with ten VLAN interfaces that have IP address from different subnet and SNMP Configured . when I try to discover switch with all subnet , it shows me...
HI, I know this is basic but is giving me a lot of head ache.I had a /30 between the Router(3925) and the ASA(5515).Installed EHWIC on the router to support ASA failover.I loose connection when I change the mask at /29. So currently the vlan interf...
