Switching

I know this has been discussed, but my situation may be more unique. We were having issues with a 24 port POE 3850 not being able to power all necessary cameras (13 I believe). It has two 710w power supplies which is more than enough for this applica...

cisco nexus 9000 c93180yc-ex  SNMP configuration  for whatsup gold 24.0 build 2096  We are getting credentials error after configuring the SNMP for Whatsup gold.  

I am curious about configuring bandwidth restrictions for specific VLANs through a switch. For example, restricting a guest Wi-Fi VLAN to 10 Mbps. While this can typically be done via a wireless controller, the customer requires this to be configured...

Greetings!  Let me start by saying I am NOT a network engineer, so I am just now learning how to configure VLANs on switches.What I want to do is to set up two separate VLANs on a SG-200 switch that are totally isolated from each other, replacing two...

Good afternoon everyone,Came across a curiosity as I was doing some network hardening for my campus network. I started blanketing access switch interfaces, spread across many vlans, with a configuration that included "ip verify source"~~ex.interface ...

I have been task to turn a immature network into something that looks more standardized. I wanted to create a Network Design with Collapse Distro & Core with a single WAN connection and two core/distro switches. Question 1.) For FHRP, what connection...

We are in the process of replacing a legacy Juniper Core switch with a 2 stack Cisco 9300 configuration.The VM Hosts within the environment are all configured in the current Vlan 1 on the Juniper switch.We are trunking to these hosts.We have the foll...

Hello to all, 877 have just brought a shindy but I have problems to form the fastethernet, on having tried to form an ip address it(he,she) appears: IP addresses may not be configured on L2 links.Since I can solve it? I have tried to use the SDM but ...

I have a pair of 6880-Xs in a VSS pair with a strange configuration. I wanted to get some opinions before changing anything. The switches are connected by MM fiber as follows:Te1/5/1 <-> Te2/5/1Te1/5/2 <-> Te2/5/2The port states are:Te1/5/1 - connect...

Our IP address on our domain controller has changed.  Do I need to change the IP address in all the configuration on the switches that were associated with that IP address?  For example the command line was -"ip host FQDN 12.12.12.12" and now we have...

Hello all, I am trying to get into ROMMON on a C9300 switch. I was attempting to get the switch on our Meraki dashboard and missed a step during the configuration/onboarding and would need to start the process over. I have followed the steps as indic...