Switching

Hi all: I have a ME-3400EG-12CS-M and is dropping packages when I perform a ping on any port. IOS version is 12.2(50)SE1... I´m using the electrical ports... Any idea what is going on?---Posted by WebUser Milton Rodolfo Pardo Moreno from Cisco Suppo...

What reason may be there that power supply temperature is critical .....its 127 degree celcius......threshold is 95

Hi all,We have a site with MST deployed to load balance traffic for a small number of Vlans. There are explicit Vlan to instance mappings defined. I need to create a new Vlan that is currently mapped to instance 0, by default. 1 & 2 are in use for Vl...

Group,Wanted to get your input on an issue where I am sure I am overlooking something. I rebuilt the router for IP SLA and PBR but I am having a VPN issue. Here is the scenario:The LAN is 10.41.14.0/255.255.255.0On the LAN is a VPN device for the net...

hi all ,i ahve router to get negotiated ip from isp by issdn bri interface :i have :Router#sh isdn stGlobal ISDN Switchtype = basic-net3ISDN BRI0 interface        dsl 0, interface ISDN Switchtype = basic-net3    Layer 1 Status:        ACTIVE    Layer...

What type of risk/impact is there when enabling jumbo frame on Nexus 7K. 

Dear Folks,Emergence of this strange issue in our network, made us to go disturbed a lot . . . Enabling L3 switch interface conecting to Nexus 7K, increases latency inbetween this as well traffic passing on through it.Checking interface of L3 switch ...

Hello,I am interesting if anyone were successful to implement HSRP isolation on Cat 6500Sub2t or Cat 4500X platforms in Data Center environments?Basically I am interesting if I can implement egress traffic optimization with these platform in Active/A...

We just installed 12 AP's on a Cisco 3560 POE switch which currently has 6 AP's already connected to it.The Customer is asking us to montior the power consumption on  the switch.What are the recommended methods for accomplishing this?Thanks You for a...

I have a stack of two 3750X's (WS-C3750X-24P-S) running c3750e-universalk9-mz.150-1.SE3.bin.One of them (the master at the time) crashed on 27/28th Feb & appears to have kept restarting and crashing again.Here is the syslog...Feb 28 04:11:28.770: %PL...